You are here: RADIO > SETUP > Console

CONSOLE

To make the automatic filming work, the system must recover in real time the microphones’ audio level (or the detection of speaking).

To do this, you have to configure the IP communication with the audio console.

Here you can view the list of supported consoles

Start by selecting your console model.
If the console manufacturer offers “Audio Over IP” (AOIP) drivers, select AUDIO-DETECTOR.

Then enter the console IP address and click on

If the sending of each audio slice information is properly configured for the console, you will see the microphones listed and an outline circled in red upon each detection.

The detection corresponds to an audio level threshold being reached. It can be adjusted differently for each microphone. As a default, it is adjusted at -20dB.

End of the configuration!

You can leave the configuration mode by clicking on .

You will then switch to the LIVE interface.

You can go back to the configuration at any time by clicking on , and adjust the Presets or start the PROGRAM configuration.